installation notes
using the 4 mounting holes at the bottom, according to the on-site installation space and machinery facilities needs, direct installation or additional protection or other mechanical uses.
stainless steel cable installation, it should be noted that horizontal angle, which make cables from outlet to move parts of the bodies, sliding at a working level.
angle is kept to a minimum (permitted deviation +/-3.) in order to ensure measurement accuracy and life of the cable.
cable body is covered (coating), a layer of fluoride (fluorin), do not let the forces of cuts, burning processes, impact and other improper things happening: too much dust, accumulating Wood scraps or big enough to destroy cable article retention in internal pulleys or outlet will cause cable damage, leading to operation go wrong in failures.
products were not installed on the table or to sit front, do not pull the cable out and put their hands or other product instant bounce back on their own. This will have the cable break, hurt the body structure and security.
WPS-S-P and WPS-M-P series of reciprocating motion acceleration must not exceed 1 m/s; WPS-L-P and WPS series reciprocating motion of the instantaneous acceleration must not exceed 0.5 m/s; this will have cable break, are outside the scope of the company does not assume this responsibility.
If used for non-linear motion of bodies, please install the appropriate slide the round function.
If used in adverse environments or special occasions, please add a protection agency, or negotiate with this company's Engineering Department, dealers, or cause damage to the product, the company is not responsible for . 
7. wire current signal be sure to connect the load again after use. will cause overload damage to the product. Reference URL: http://www.hawkinkjet.com/products/shopmore.asp?id=4