everybody generally knows heat conduction oil stove cleaning normal cleaning time is approximately 5-7 days, a total of 7-10 days. the knowledge about specific methods of operation of the heat conduction oil stove cleaning what do you know? Here Kitty cleaning to do for you in detail.
emissions out of old oil: heating system, the thermal oil is heated to 70-80, all heat transfer oil in the hot exhaust system, under conditions so that residual oils emit as much as possible within the system, adding cleaning agents through osmosis that I put, split, dissolution after the thinning of the oil, and exhaust systems.
pre wash: cleaning agents by circulating water 1.5-2% measurement of total dissolved in any part of the heating system into the system, filled with water to the system, open the circulation pump circulation, use of furnace water temperature rises to 60 ℃ ± 5 ℃, switch each autoclave valves in the system, allowing the system to all parts of the loop respectively. 3-5 hours later, the temperature rose to 95 degrees Celsius, all the lower drain valve open systems, the water in the drainage system.
cleaning: cleaning agents by circulating water 4.5~6.5% measurement of total dissolved in any part of the heating system into the system and when the system is filled with water, open circulation pumps for circulation, use furnaces to heat cleaned to 90 ℃ ± 5 ℃. the switching valve, cleaned all parts are available within the system, valve switch pressing once every hour is appropriate. the entire cleaning time of not less than 24 hours. (If you switch the valve more longer cleaning time).
washing: fill it up with water to the system, open the circulation pump circulation, use of furnace water temperature rises to 90 ℃ ± 5 ℃, switch valve in the system, allowing the system to all parts of the loop respectively. to rinse the system, three hours later, all the lower drain valve open systems, the water in the drainage system.
washing: fill it up with water to the system, and turn on the pump for circulation, use of furnace water temperature rises to 90 ℃ ± 5 ℃, switch valve in the system, allowing the system to all parts of the loop respectively. to rinse the system, three hours later, all the lower drain valve open systems, the water in the drainage system.
washing: fill it up with water to the system, open the circulation pump circulation, use of furnace water temperature rises to 90 ℃ ± 5 ℃, to rinse the system, three hours later, all the lower drain valve open systems, the water in the drainage system. the determination of the PH value of the water close to 7, emission completed after discharge is complete, according to conditions, using compressed air blowing system until the residual water to drain away.
with the new oil: within the system, a new HTF .
dehydration: dehydration dehydration before using standard methods and the new system.
normal operation: the system is put into normal operation.
on heat conduction oil stove cleaning above the main troupe of specific methods of operation. I hope to help you. we believe seriously, products can be done better. kaidi chemical you are welcome to come to buy, willing to work with you to create a better tomorrow. kaidi chemical cleaning agent for heat transfer oil products: KD-L312 oil cleaning agents, has been upgraded for the third generation oil furnace cleaning products.