HomePage|PreviewCard Introduction Products News Culture Honer History Company Card

News>the safe use of jackhammers sleeve notes the safe use of jackhammers sleeve notes Source：http://www.qcgjc.comDatetime：2014-12-19 Brief:the safe use of jackhammers sleeve notes air gun sleeve when we used jackhammers sleeve, be sure to pay attention to safety and avoid unexpected loss, is the safe use of jackhammers sleeve Note: 1, the gas supply pressure exceeds the tool should be used when using a pressure regulator, operator and maintenance people should be required to not wear loose clothes. 2, air supply hose should use pressure-resistant and oil-resistant and wear-resistant surface on the inner surface of the hose, hose should be securely fastened to connector. 3, gas hose, fittings, clamp (Hose Clips) should periodically check that when an exception is found, time for repair or replacement. 4, jackhammers sleeve maintenance after commissioning, should be carried out on fire in an enclosed area and allows high-speed test run for a short time only. 5, start before the first check tools and protective equipment in good condition, clamped properly, without loosening tools part no cracks; also check gas seal well, and aging, corrosion-free, pressure source security devices in good condition, air duct connection firmly. 6 when, startup, the first commissioning. should be smooth no violent vibration after start, check the dynamic, working again. Automatic shutoff valve 7, jackhammers sleeve should remain intact, guarantee operation, only started running, in order to work. 8, when using a pneumatic drill sleeve shall hold the hold, cannot be slippery or contaminated hands, attention was focused on, in case people injured by falling off job. 9, knocking help tapping near the face, check for job barriers near the work area, debris, and clean, to avoid accidental injuries caused by fall. 10, when using a pneumatic drill sleeve, pay attention to a standing position and location must not depend on the body pressure, hard play, death, chosen gun sleeve overall reversal of cuts. 11, jobs not found in normal voice should stop check, find out and eliminated, can continue to demand job. 12 hit the wind lost, no gravity gun sleeve, after work, should promptly close the gas supply line valve, cleaning machines, thread a hovering in place. 13, jackhammers sleeve should be specifically responsible for checking, custody, maintenance on a regular basis. after reading the above, you should be safe use of jackhammers sleeve notes have a certain understanding, wish I could help you.。3