when unloaded (compression) garbage truck maintenance

side-mounted rear unloading (compressed) garbage truck maintenance:

1, chassis, and engine parts maintenance stipulated in the chassis manual. 

stage 2, new cars go, miles, 1500-2500km and unloading up to 900 times, load with rated contained mass 70%, unloading blast engine not MN on the gas. 

in cylinder 3, 300 times, all that oil should be replaced., unscrew the hydraulic tank oil drain plug, and then from the Upper Canada inject new oil into the oil hole, and then start the engine, try running the cylinder action twice, known and reliable. 

4, high pressure oil pipe replaced on a regular basis every two years. found in the use process phenomena such as the expansion of cracking, damage, shoulders, should be changed. 

5, always check the hydraulic system oil leakage, and timely maintenance and replacement of seals. 

6, lubricating motor general purpose lithium base grease (GB5671-85), oil guns penetrate from the nozzle, until the gap in out so far. 

7, after the end of a day job cleaning vehicle and the inner surface of the trunk and check the elevator chute. always check the hydraulic oil stock, regularly to moving parts lubricated, the rail grease on the surface. 

8, periodic checks and BDSM gear oil pump pressure; check the oil filter cartridge, remove surface impurities or replacing the filter element; regular replacement of hydraulic oil. 

information from: http://www.szclwtq.com/jishuziliao/1899.html

the official website: http://www.szclwtq.com/