notes on side-mounted box structure of compression refuse collector trucks

side installed compression refuse collector car structure Description:

1, compartment structure

Cheng Li side installed compression refuse collector car with standard quality profile, excellent low-alloy the structural steel and manganese steel, welded together, reatures high strength, light weight, structure solid and reliable agencies. carriage for the entire seal structure, and box at the back door with a seal, pull back on the back door shut off the back door can be completely sealed tight, carriage Interior water inside all the sewage discharged into the box below, to avoid corrosion case and chassis, as well as to avoid ride to curb sewage spill, effective prevention of secondary pollution. compartment front push plate can be coated inside with waste over backward or shirk, squeeze waste and be able to play a , effectively increasing the load space.
2, lifting mechanism
used for the side-loaded and compressed rubbish vehicle hoist lever-type structure, upper cover on both sides of the trunk (feeding) led two hydraulic cylinders, Thong lever CAP and riser board movements are connected together, in the course of work, as the trash can rise, build gradually on open, finally fully opened. during the entire hanging barrel, double barrel is accurate does not cause misoperation and body gets hurt; hoist can be equipped with hanging drum, plastic barrels and barrel with upgrade.
3, back body
backdoor uses high strength low alloy steel plate and profiles welded together, side-loaded and compressed rubbish vehicle controlled by hydraulic, and install the locking mechanism, high strength, reliable and so on, and can withstand a certain amount of extrusion force; rear door seal, back at the back door closed box are fully sealed; the Agency travel control valve or switch is installed, to avoid errors in operation.
4, hydraulic system
side-loaded and compressed rubbish vehicle hydraulic cylinder circuit control pneumatic, hydraulic pneumatic valve control valve body, Hydraulic multi-way valve controlled cylinder . the operation is simple and reliable, but also have to manually direct operated hydraulic multi-way valve, with single hydraulic system control. side-loaded and compressed rubbish vehicle hydraulic system consists of tank and filtration systems, pumps, valves, one-way throttle valve, cylinders, tubing and other components. System powered from the engine, power by taking out the power, PTO driven gear pump. gear pump oil oil filter hydraulic oil in the hydraulic oil tank breathing and multi-way valve (located outside the cab, vehicle after box front) for oil. the multi-channel valves work, lift cylinder, push suet cylinders or cylinder, the back door lock cylinder movement, hydraulic cylinder is not working, hydraulic oil after a multi-way valve directly back to the fuel tank.

information is from: http://www.szclwtq.com/jishuziliao/1894.html

official website: http://www.szclwtq.com/